J'ai un PC Windows 10 (64 bits, 8 Go de RAM) avec carte son intégrée en 5.1, driver realteck, et quand je lance un programme de simu type Amplitube 4, il y a un son horrible qui sort, est-ce normal ? Y a-t-il un moyen d'y remédier ? Je suis débutant et rencontre quelques soucis. Don’t set it too low, though, because it’s better if your speaker does move some air.Įxperiment, try different amp settings and see whether that changes the results. I did not get better results with very high levels than with normal, humanely bearable levels. I tried various volume levels, and it did not affect the results notably. I think a level high enough to cover your own conversational voice should be enough. As for the volume, set it to a level that’s high enough for your microphone to be able to pick up a good signal (no need to record higher than -6 dB, by the way, give your signal a bit of headroom).īut you should also be careful not to set it too loud to protect your own ears. You’re not capturing the amp sound, but the speaker sound.įrom what I’ve experienced, the EQ and Presence should be neutral, the gain/saturation should not be engaged (or set to a level where no distorsion can be heard). Chances are there’s not much of a difference, but again, I may be wrong as I have not tried this myself.Ībout the choice of a channel, and the settings: the channel doesn’t actually matter. I guess there’s no harm trying both (not at the same time!) and comparing if you have that possibility. Actually, the amps I’ve used myself to make IRs don’t have any FX return, so I didn’t have a choice and had to plug into the guitar jack. What should my Amp settings be (EQ, Gain, Channel Volume, Presence, Master Volume)? I can't find a clear answer anywhere.Ībout plugging into the FX return or the guitar jack, I don’t know. What channel should my amp be on? I'm assuming the clean channel. What is the purpose in doing one or the other? My question, then, is when I plug into the Amp I've seen people say plug your Interface out into the FX return, but you say the guitar cable jack. This is correct based on my understanding from what I've read, and the few videos I've watch on creating IRs. DAW > Audio Interface Out > Amp > Speaker > Mic > DAW
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |